2004 Ski-Doo Elite Factory Service Manual, Page 288Get this manual
Section 09 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
All long tie-rod end using nut, need hardened washer no24 on each side of the part where the tie-rod is installedNote position of the hardened washer no24 on short tie rod endRefer to exploded view at the beginning of this subsection
A02G0IA
TYPICAL 1Parallel with steering arm 2Steering arm
WARNING
The cut off section of the ball joint must run parallel with the swivel bar no27When tightening lock nuts, restrain ball joint with appropriate size wrenchThe maximum external threaded length not engaged in the tie rod must not exceed 20 mm (2532 in)After jam nut tightening, you should be able to rotate long tie rods by 20 and short tie rod by 10
A32G0OA