2004 Ski-Doo Elite Factory Service Manual, Page 280Get this manual
Section 08 REAR SUSPENSION Subsection 03 (TRACK)
Restart engine, rotate tracks slowly and recheck alignmentIf the satisfactory alignment is achieved, then tighten the idler wheel retaining screws to 48 Nm (35 lbfft)
Track Cleat
Removal Raise rear of vehicle off the ground and lift snowguard then hand rotate track to expose cleat to be replaced Use track cleat remover (PN 529 028 700) for all modelsInstallation Place new cleat in position on the track and using narrow track cleat installer (PN 529 008 500) bend cleat then push tabs into rubber Re-open installer, then position cleat tabs on open end of tool and squeeze tabs until they are indented in rubberA01B4UA