2004 Ski-Doo Elite Factory Service Manual, Page 276Get this manual
Section 08 REAR SUSPENSION Subsection 02 (DRIVE AXLE)
REMOVAL
Raise and block rear of vehicle off the groundRemove suspension on appropriate sideRefer to proper subsectionRemove speedometer sensor no11 or end bearing housing plastic cap no1 depending on the side of drive axle removal Remove brake caliper on appropriate sideRemove sprocket plate no12NOTE: Drive axle can be removed without extracting brake disc and end bearing no8Pull drive axle out of vehicle through brake disc access holeRemove outer flange no10 and circlip no9Remove end bearing no8 and brake disc from drive axle
A00F07A
TYPICAL 1Pipe
Sprocket and Half-Sprocket
To remove press fit sprockets no5 and no6, use press and suitable support as illustratedA34D0FA