2004 Ski-Doo Elite Factory Service Manual, Page 270Get this manual
Section 08 REAR SUSPENSION Subsection 01 (SC-10 III SUSPENSION)
SUSPENSION ASSEMBLY REMOVAL
Lift rear of vehicle and support it off the groundRemove flanged nuts no29 and pull out stabilizing bar no302 2
A34F0CA
Remove nut no27 on bottom end of shockInstallation is reverse of removal procedureCAUTION: Take care not to damage grease fittings
Front Shock
Unfasten one end of stopper strap(s)Unbolt shock no8 from the topRemove the front idler wheel no28 to gain access to the axle retaining self-locking screws no5Follow the instructions provided in this section to unfasten these screwsSlide out the axle and remove the shockA34F0DA