2004 Ski-Doo Elite Factory Service Manual, Page 263Get this manual
Section 07 ELECTRICAL SYSTEM Subsection 03 (ELECTRIC STARTER)
NOTE: If starter does not mesh properly, try to pull it out and slightly rotate the starter gear; then reinstall starterOne could also temporarily remove both O-rings, properly mesh gears then remove starter to reinstall O-rings, being careful not to rotate gear to keep its position, to finally reinstall starterApply Loctite 243 (blue) on retaining screws no1 and torque to10 Nm (89 lbfin)Connect the RED positive cable to the starter and torque nut to Nm (62 lbfin)Apply dielectric grease on terminal and nutSTARTER SPECIFICATION