2004 Ski-Doo Elite Factory Service Manual, Page 262Get this manual
Section 07 ELECTRICAL SYSTEM Subsection 03 (ELECTRIC STARTER)
Yoke Assembly and Clutch Housing
Align previously traced indexing marksTo ease end frame installation, retain brush holder with small screwdriver while installing end frameF01H0QA
TYPICAL 1Align marks
Open brushes and slide over commutatorAlign end frame locating notch with yoke locating protrusion and properly sit brush holder into yoke1
F01H0UA
TYPICAL 1Retaining brush holder with screwdriver 2Align here
Align end frame notch with brush holder notch yoke protrusionCAUTION: Make sure end frame fits perfectly on yokeApply Loctite 271 (red) on through bolts threads and torque to Nm (53 lbfin)1