2004 Ski-Doo Elite Factory Service Manual, Page 249Get this manual
Section 06 TRANSMISSION Subsection 06 (GEARBOX AND FINAL DRIVE BELT)
To adjust, loosen lock nut no8 and turn fork axle accordingly
REVERSE SWITCH ADJUSTMENT
Short to ground the ORANGEWHITE wire of VCMRefer to TESTING PROCEDUREShift in reverseReverse alarm must soundIf not, unplug reverse switch to avoid twisting wires, loosen lock nut and screw switch in
A34D0MA
DRIVEN PULLEY REMOVED 1Fork axle end
Before tightening lock nut no8, position ball joint no10 90 to pivot no7 to allow proper ball joint free rotationShift in forward positionCheck if pivot no7 is at least 0.5 mm (.020 in) from stopper
A34D0LB
1Reverse switch