2004 Ski-Doo Elite Factory Service Manual, Page 231Get this manual
Section 06 TRANSMISSION Subsection 02 (DRIVE PULLEY)
WARNING
Ensure that the track is free of particles which could be thrown out while track is rotatingKeep hands, tools, feet and clothing clear of trackEnsure nobody is standing near the vehicleAccelerate the vehicle at low speed (maximum 30 kmh (20 MPH)) and apply the brake, repeat timesRetorque screw to 125 to 135 Nm (92 to 100 lbfft)
Governor cup has positions numbered to 6To Adjust: Just loosen locking nut enough to pull calibration screw partially out and adjust to desired positionDo not completely remove the locking nutTorque locking nuts to 10 Nm (89 lbfin)CAUTION: Do not completely remove calibration screw otherwise its inside washer will fall offCAUTION: Always adjust all calibration screws and make sure they are all set at the same number