2004 Ski-Doo Elite Factory Service Manual, Page 220Get this manual
Section 06 TRANSMISSION Subsection 01 (DRIVE BELT)
DRIVE BELT
APPLICATION CHART
MODEL Elite PART NUMBER 417 300 207 MINIMUM WIDTH (wear limit) mm (in) 34.2 (1.346)
INSPECTION
Inspect belt for cracks, fraying or abnormal wear (uneven wear, wear on one side, missing cogs, cracked fabric)If abnormal wear is noted, probable cause could be pulley misalignment, excessive RPM with frozen track, fast starts without warm-up period, burred or rusty sheave, oil on belt or distorted spare beltCheck drive belt widthReplace the drive belt if width is under minimum recommended width (see table above)
CHECKING NEUTRAL FUNCTION
WARNING
Always check neutral function when servicingApply parking brakeVehicle must be on the ground and on plane level surfaceNo one should be in front of vehicleAttach vehicle DESS tether cord to your clothingSit in vehicle and properly fasten safety belt, then start engineRelease parking brakeVehicle must not creep when engine is idlingOtherwise, make sure that: idle speed is as specified proper belt is installed pulley center-to-center is as specified belt deflection is as specifiedA01D2KA