2004 Ski-Doo Elite Factory Service Manual, Page 201Get this manual
Section 05 ENGINE MANAGEMENT Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
Connect the CPS, KS, OPS, and the MAPS to the wiring harnessAlso connect now the TPS, OSPS, idle bypass and TOPS resistance to the wiring harnessInstall all remaining parts, which has been removed
THROTTLE POSITION SENSOR (TPS)
General
R1503motr202A
1Locking tie
The throttle position sensor (TPS) is potentiometer that sends signal to the ECM ECU which is proportional to the throttle shaft angle
Connect the fuel injectors, ignition coils, CAPS and CTS to the wiring harness
WARNING
Pay attention not to mix injectors or ignition coils wires between cylindersThe location of the splice connectors indicate which cylinder wires belong toInstall the engine connector on the appropriate bracket on the wiring supportThen fix the other bundle on the appropriate supports on the wiring support and the ECM ECU bracket with locking tiesR1503motr325A