2004 Ski-Doo Elite Factory Service Manual, Page 194Get this manual
Section 05 ENGINE MANAGEMENT Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
Slide old resistor card ass'y out of aluminum extrusionReverse removal procedure for installationA34I01A A32I0WA
Align the arrow on fuel pump module with the one on fuel tankKeep arrows aligned during fuel pump module nut tighteningInstall torque wrench perpendicularly (90) to fuel pump nut wrench (PN 529 035 899)Torque fuel pump nut to 2730 Nm (2022 lbfft)Bleed the fuel system as following procedureFuel Bleeding Procedure The rear fuel pickup hose has to be bledPour 12 (3.17 U.Sgal of recommended fuel in the fuel tankApply parking brakeStart the engineLet it run at idle speedLift the front of vehicle at 45 anglePut the vehicle back on the groundRepeat the operation twiceStop the engineThe rear fuel pickup hose is now bled
TYPICAL 1Fuel regulator removed 2Resistor card ass'y ready to be installed 3Connectors to be unplugged 4Locking tie to be cut