2004 Ski-Doo Elite Factory Service Manual, Page 188Get this manual
Section 05 ENGINE MANAGEMENT Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
AIR INDUCTION SYSTEM THROTTLE BODY
Throttle body has been replaced and the Closed Throttle and Idle Actuator reset has not been performed ECM ECU has been replaced and the Closed Throttle and Idle Actuator reset has not been performed
Electrical Inspection
Refer to THROTTLE POSITION SENSOR (TPS) and IDLE BYPASS VALVE in ELECTRONIC MANAGEMENT below
Replacement
Removal To remove the throttle body from engine, proceed as follows: Disconnect air intake silencer from throttle bodyMove boot away Remove retaining screws of throttle body
R1503motr319A