2004 Ski-Doo Elite Factory Service Manual, Page 166Get this manual
Section 04 ENGINE Subsection 09 (ENGINE BLOCK)
NOTE: It is recommended to apply this specific sealant as described here to get an uniform application without lumpsIf you do not use the roller method, you may use your finger to uniformly distribute the sealant (unlike the Drei Bond sealing compound, using finger will not affect the adhesion)Use the silicone-based Loctite 5910 (PN 293 800 081) on mating surfacesCAUTION: Do not use Loctite 515 or 518 to seal crankcaseDo not use Loctite Primer with the Loctite 5910Using these products or non silicone-based sealant over previously sealed crankcase with Loctite 5910 will lead to poor adhesion and possibly leaking crankcaseThese products are chemically incompatiblesEven after cleaning, the Loctite 5910 would leave incompatible microscopic particlesUse plexiglass plate and apply some sealant on itUse soft rubber roller (5075 mm (2in)) (available in arts products suppliers for printmaking) and roll the sealant to get thin uniform coat on the plate (spread as necessary)When ready, apply the sealant on crankcase mating surfaces