2004 Ski-Doo Elite Factory Service Manual, Page 163Get this manual
Section 04 ENGINE Subsection 09 (ENGINE BLOCK)
NOTE: It is not necessary to have all cylinders rehoned if they are not all out of specificationMixed standard size and oversize cylinders are allowedMeasure cylinder bore at recommended positionsSee the following illustration2 B
R1503motr40A
1Bearing of starter drive assembly
Starter drive bearing can be easily removed from lower crankcase half using the following suggested tool or equivalent: Snap-on hammer puller including: handle CJ93-1 hammer CJ125-6 claws CJ93-4
R1503motr24A
First measuring diameter Second measuring diameter Third measuring diameter 60 mm (2.362 in) 110 mm (4.331 in)