2004 Ski-Doo Elite Factory Service Manual, Page 122Get this manual
Section 04 ENGINE Subsection 07 (LUBRICATION SYSTEM)
Run engine for 10 seconds at 4000 RPM and shut it off at this RPMThis will move oil from PTO housing to oil tank to allow maximum oil drainingRemove oil filler cap and dipstickUsing the Oil VAC (PN 529 035 880), siphon oil through dipstick holeCAUTION: Never crank or start engine when siphon tube is in dipstick holeNever start engine when there is no oil in engineNOTE: Since the siphon tube must be inserted at the proper depth to siphon the oil, it is suggested to put some electrical tape on siphon tube at 475 mm (18.7 in) from its endThen, insert siphon tube until you reach the tapeOIL TYPE AND SYSTEM CAPACITY
Refer to TECHNICAL DATAFor refilling procedure, refer to OIL LEVEL VERIFICATION above
OIL FILTER
Removal
Remove: engine oil (refer to OIL CHANGE) oil filter screw no1 oil filter cover no2 oil filter no31 2
A34C0ZA R1503motr281A