2004 Ski-Doo Elite Factory Service Manual, Page 104Get this manual
Section 04 ENGINE Subsection 05 (PTO HOUSING)
Place small pan under PTO housing to prevent spillageIf spillage occurs, clean immediately with the pulley flange cleaner (PN 413 711 809) to prevent oil stainsRemove: engine support (with drive shaft)See above in PTO HOUSING Oetiker clamp no11 located close to the PTO housing PTO seal no22A32C0RA
SEAL CARRIER INSTALLED ON DRIVE SHAFT 1Alternator belt loosely installed
Loosely install new collar on the seal carrierReinstall engine support (with drive shaft)NOTE: While installing engine support, turn drive shaft to mesh splinesFasten the new collar to secure seal carrier boot to PTO housingSecure engine support to engine block first, then secure to engine mountsRefill engine with oilRefer to ENGINE sectionAlign drive and driven pulleysRefer to TRANSMISSIONAdjust alternator belt tensionRefer to ELECTRICAL SYSTEMR1503motr340A