2004 Ski-Doo Elite Factory Service Manual, Page 103Get this manual
Section 04 ENGINE Subsection 05 (PTO HOUSING)
R1503motr337A
1Washer 2Disc spring 3Starter drive ass'y
CAUTION: Ensure the starter drive gear shaft is well engaged in its boreGently install PTO housingCAUTION: While installing housing, pay particular attention that gasket does not get pinched or slide out of its contact surface in the area shown in the following illustrationNever force to install coverIf there is strong resistance, remove housing and check oilcoolant pump alignment and starter gear alignmentR1503motr339A
1Screws M6 35 2Screws M6 85