2004 Ski-Doo Elite Factory Service Manual, Page 99Get this manual
Section 04 ENGINE Subsection 04 (REMOVAL AND INSTALLATION)
529 035 953
Loosely install new collar on the seal carrierOnce engine support is installed on the engine, fasten the new collar to secure seal carrier boot to PTO housing
ENGINE INSTALLATION
Before engine installation make sure the engine rubber mounts are in good conditionIf not, replace damaged partsTo install engine on vehicle, reverse removal procedureHowever, pay attention, to all appropriate componentsystem reinstallation procedures described throughout this Shop Manual and to the following: Check pulley alignment and drive belt heightNOTE: No sealant required on doughnut shaped exhaust gasket
A32C0PA
Turn the engine support upside down and position it on workshop pressMake sure the bearing support (PN 529 035 953) is supporting the ball bearing inner racePlace an aluminum or brass protection cap over splines of drive shaftPush the drive shaft into the supported ball bearingInstall ball bearing circlipCheck for smooth drive shaft turningInstallation IMPORTANT: Loosely install the alternator belt on multi-rib pulley before engine support reinstallationRemove seal carrier from PTO cover and install it on the drive shaft