2004 Ski-Doo Elite Factory Service Manual, Page 51Get this manual
Section 02 MAINTENANCE Subsection 02 (STORAGE)
WARNING
If leak is present, immediately stop the engineDo not start engine until the leak is repaired
WARNING
At preseason preparation, ensure to perform fuel pressure test and ensure there is no leakAlso run engine and check for leaksRefer to ENGINE MANAGEMENT section Pull engine cover upward to remove it Disconnect ignition coil connectorsF18M01A
WARNING
When disconnecting coil from spark plug, always disconnect coil from main harness firstNever check for engine ignition spark from an open coil andor spark plug in the engine compartment as spark may cause fuel vapor to igniteIMPORTANT: Never cut the locking ties of coil connectorsThis would allow mixing the wires between cylinders Remove ignition coilsCAUTION: Ensure there is no dirt in coil holes prior to removing the spark plugsOtherwise, dirt would fall into cylinders and will damage the internal components Remove the spark plugs Apply BOMBARDIER LUBE storage oil (PN 413 711 600) for Canada and (PN 413 711 900) for USA lubricant into the cylinders Reinstall spark plugs and ignition coils Reconnect ignition coil connectorsNOTE: Prior to inserting the ignition coil in its location, apply some Molykote 111 grease (PN 413 707 000) around the seal area that touches the spark plug holeAfter installation, ensure the seal seats properly with the engine top surface To reinstall engine cover, push it downward until it snaps Crank engine several times while keeping throttle fully depressed to distribute lubricant on exhaust valves