2004 Ski-Doo Elite Factory Service Manual, Page 17Get this manual
INTRODUCTION
NOTE: Avoid grinding Clean both mating surfaces with solvent Spray Loctite Primer on both mating surfaces and on both sides of gasketAllow to dry or minutes Apply gasket eliminator 515 (PN 413 702 700) on both sides of gasket, using clean applicator Place gasket on mating surfaces and assemble immediatelyNOTE: If the cover is bolted to blind holes (above), apply proper strength Loctite in the hole and on threadsTightenIf holes are sunken, apply proper strength Loctite on bolt threads Tighten as usual
Mounting in Tandem Apply retaining compound on internal element bore Continue to assemble as shown above
CASE-IN COMPONENTS
Metallic Gaskets
MOUNTING ON SHAFT
Mounting with Press
A00A3VA