2003 Ski-Doo ZX Series Factory Shop Manual, Page 348Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
8,17,18, Tie Rod and Ball Joint
Turn handlebar until bolt center of left side swivel arm is 11 mm (2764 in) from chassis hole center
Loosen the jam nuts on tie rod no8 (LH threads on steering column end) and turn tie rod accordinglyRetighten the jam nuts to 18 Nm (159 lbfin)
WARNING
Never lengthen this tie rod so that the external unengaged threaded portion of ball joint exceeds 20 mm (2532 in)CAMBER NOTE: Identical adjustments are required on both sides of the vehicle Make sure the vehicle is leveled by placing an angle finder under the main frame member as shown on the following illustration Vehicle skis must be off the ground
A32G0LA
1Left side swivel arm A11 mm (.443 in)
Check that handlebar is horizontal by measuring from the extremities of the grips to the rearmost edge of the tunnel, as shownNOTE: The reference point must be the same relative to each sideA06G05A