2003 Ski-Doo ZX Series Factory Shop Manual, Page 334Get this manual
Section 07 REAR SUSPENSION Subsection 05 (TRACK)
Restart engine, rotate track slowly and recheck alignmentIf the satisfactory alignment is achieved, then tighten the idler wheel retaining screws to 48 Nm (35 lbfft)Reinstall the wheel caps
Track Cleat
Removal Raise rear of vehicle off the ground and lift snowguard then hand rotate track to expose cleat to be replaced Using track cleat remover (PN 529 028 700) for all modelsInstallation Place new cleat in position on the track and using narrow track cleat installer (PN 529 008 500) bend cleat then push tabs into rubber Re-open installer, then position cleat tabs on open end of tool and squeeze tabs until they are indented in rubberA01B4UA