2003 Ski-Doo ZX Series Factory Shop Manual, Page 330Get this manual
Section 07 REAR SUSPENSION Subsection 04 (DRIVE AXLE)
ASSEMBLY
3,5,6, Drive Axle and Sprocket
To assemble press fit sprockets, use press and suitable pipe as illustratedSprockets must be assembled according to the following dimensions1
A24D05A
TYPICAL 1Indexing marks aligned
A00F07A
TYPICAL 1Pipe
The maximum desynchronization for the sprockets is 1.5 mm (116 in)To check this tolerance, place axle assembly on plane surface and measure the gap between sprocket tooth and surface
ZX Series