2003 Ski-Doo ZX Series Factory Shop Manual, Page 224Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
Place extractor (PN 529 035 575) below bushing
A03D1WB A03D2SA
TYPICAL 1Support plate 2Extractor
1BLACK slider shoe 2RED slider shoe
Mount screw head of new puller (PN 529 035 524) in viseTurn pulley half by hand to extract old bushingBefore bushing installation, file sliding half bore to remove burrs from crimping areasCoat bushing outside diameter with Loctite 609 (PN 413 703 100)Place new bushing on sliding half and slightly tap to engage squarely the bushing in the sliding