2003 Ski-Doo ZX Series Factory Shop Manual, Page 217Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
21,22,23, Screw, Dowel Tube and Ramp
Insert dowel tube from chamfered sideMake sure ramp is centered on dowel tube9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
TRA III NOTE: While installing lever assemblies make sure that the curved sides of the levers are outwards as shown
A16D08A
1Chamfered side
Position dowel tube split at the angle AA
A32D1ZA A16D2PB
MODEL With TRA With TRA III