2003 Ski-Doo ZX Series Factory Shop Manual, Page 216Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
9,12, Fitting Bolt Ass'y and Flanged Bushing
Check for wear, replace as required
24,25, O-Ring and Slider Shoe
Check if O-rings are cracked, cut or crushedReplace as requiredCheck slider shoes for wearReplace if groove is not apparent on top
CAUTION: Bushing must be bonded with retaining compoundApply retaining compound Loctite 609 outside of bushing then press it down to counterbore from outside endCAUTION: Insert bushing from sliding half side (inner side) of spring cover
ASSEMBLY
NOTE: This drive pulley is lubrication freeDo not lubricate any component
5,29, Fixed Half and Governor Cup
Inspect splines and free play between both partsMaximum free play is 0.5 mm (.020 in) measured at calibration screw radiusReplace if required
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (PN 413 702 900) on threads and then torque to 27 Nm (20 lbfft)