2003 Ski-Doo ZX Series Factory Shop Manual, Page 192Get this manual
Subsection 10
Section 04 ENGINE (CARBURETOR AND FUEL PUMP)
As confirmation, the gap between the stopper and the bracket should be within and 0.5 mm (0 and 164 in)
Idle Speed Final Adjustment
CAUTION: Before starting engine for the final idle adjustment, make sure that oil pump is adjustedThe oil injection pump adjustment must be checked after each time carburetor idle is adjustedRefer to OIL INJECTION SYSTEMStart engine and allow it to warm then adjust idle speed to specifications by turning idle speed screw clockwise to increase engine speed or counterclockwise to decrease itRefer to TECHNICAL DATA for the specificationsCAUTION: Do not attempt to set the idle speed by using the pilot screwSevere engine damage can occur
Some Models
A32C32A
TESTING
Air Temperature Sensor