2003 Ski-Doo REV Series Factory Shop Manual, Page 276Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
INSTALLATION AND ADJUSTMENT HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed lineBULB REPLACEMENT
Headlamp
If any headlight bulb is burnt, open side panelUnplug burnt bulb connectorRemove the rubber bootUnfasten bulb retainer ringDetach the bulb and replaceProperly reinstall parts
A30E05A
A02E0AA