2003 Ski-Doo REV Series Factory Shop Manual, Page 265Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
2Hook rubber cord in front of skis to keep them closed and to take all slack from steering mechanism3Leave the vehicle on the ground on its own weight4Place straight edge against pre-adjusted track and measure the distance between front and rear of ski bridgeTo reduce tolerance when measuring, set one ski to proper toe-out (half the total toe-out) then measure from that ski to the opposite ski
Once ski alignment is done check that ski leg rests against lower arm when the handlebar is fully turnedCheck on both sides1
A33G0HA
RIGHT HAND SIDE SHOWN 1Ski leg 2Lower arm
A33G0IA
TYPICAL 1Straight edge 2Rubber cord 3Measure at rear and front of ski bridge