2003 Ski-Doo REV Series Factory Shop Manual, Page 260Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
If, for any reason, the master cylinder has been removed from handlebar note that its clamp must be installed with the embossed arrow pointing downwardRefer to HANDLEBAR POSITION ADJUSTMENT for handlebar reinstallation
For proper torque specifications refer to the specific exploded view for the vehicle being serviced1 2
14, RH and LH Swivel Arm
At assembly respect UP mentionTheir grease fitting no26 must face toward center of vehicleA02G0IA
TYPICAL 1Parallel with steering arm 2Steering arm
WARNING
The cut off section of the ball joint must run parallel with the swivel bar no9When tightening lock nuts, restrain ball joint with appropriate size wrenchThe maximum external threaded length not engaged in the tie rod must not exceed 20 mm (2532 in)