2003 Ski-Doo REV Series Factory Shop Manual, Page 259Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Brake Side: Unclip windshieldUnplug connectors from brake light switch located on master cylinder no22
CAUTION: Installing grip without the insertion tool is likely to damage its heating elementPosition the insertion tool at the outside end of gripUsing plastic hammer, tap on tool to push grip onContinue to tap until grip bottoms1 2
A33G0FA
1Connectors unplugged
Unplug LH harness on top of steering columnCut locking ties retaining brake light switchheating grip harness to handlebarUsing the multilock-terminal housing extraction tool AMP (PN 755430-2), push the wires of the heating grip harness out of connector housingNote the position of the wires for reinstallationPull heating grip wires out of brake light switch heating grip harnessInsert the open side of 23 mm (78 in) wrench against the inner end of gripCAUTION: Pay attention not to damage wires with the wrenchUsing plastic hammer, tap on the side of the wrench end to make the grip sliding outInstallation is the opposite procedure of the removal but pay attention to the followingClean handlebar ends and inside of heating grip with isopropyl alcoholLet dry before installation