2003 Ski-Doo REV Series Factory Shop Manual, Page 223Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
When cables are connected beeping signal from the reverse buzzer will be heard (if vehicle is so equipped)This indicates that the MPEM is now ready to transfer programming operationsOnce MPEM calibration program checking is done, unplug volt adaptor and supply cable
Select no3 CALIBRATION
1TIMING ADJUST 2ENGINE SERIAL#AT N
PROCEDURE
Turn on programmer then enter passwordFrom main menu select no3VEHICLE INFO;
A30E2IA
Press ENTER TrsFollowing screen appears temporarily:
A30E1XA
CHECK KEYS PROGRAM KEY VEHICLE INFO TA RT H
VERIFY PGMR MPEM