2002 Ski-Doo Shop Manual Volume Two, Page 233Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
All Models Lock the handlebar in place by tightening the nuts as specified in the illustrationsCAUTION: Tighten the nuts equally in crisscross sequence and ensure there is an equal gap on each side of the clamps
STEERING ADJUSTMENT (skis)
Definitions
TOE-OUT: difference measured between the front edge of the skis "A" and rear edge "B" as viewed from the topIt is adjustableFor all CK3 models, toeout is measured at 220 mm (8-2132 in) from ski pivot bolt axisA 220 mm 1
A01G04D A30G0HA
TYPICAL 1Torque to 23 Nm (17 lbfft) AEqual gap all around
TYPICAL 1Ski pivot bolt axis
WARNING
Avoid contact between the brake handle and the windshield by NOT adjusting the handlebar too high