2002 Ski-Doo Shop Manual Volume Two, Page 223Get this manual
Section 07 REAR SUSPENSION Subsection 04 (TRACK)
NOTE: Torque retaining screw to 48 Nm (35 lbfft) after adjustmentTighten the idler wheel retaining screws
Track Cleat
Removal Raise rear of vehicle off the ground and lift snowguard then rotate track to expose cleat to be replaced Using track cleat remover (PN 529 028 700) for all modelsInstallation NOTE: Keep the same pitch between guide cleats Place new cleat in position and using narrow track cleat installer (PN 529 008 500) bend cleat then push tabs into rubber