2002 Ski-Doo Shop Manual Volume Two, Page 219Get this manual
Section 07 REAR SUSPENSION Subsection 03 (DRIVE AXLE)
CK3 SeriesA00F0AA
1Plane surface A1.5 mm (116 in) MAXIMUM
A06D1XC
Measure from end of drive axle 49 mm (1.929 in) 151.2 mm (5.953 in) 274.2 mm (10.795 in) 376.3 mm (14.815 in)
CAUTION: The same sprocket must not be pressed twice on the axleIf synchronization is found to be defective, use new sprocket
11, Bearing Protector
At assembly, flat side of bearing protector must be against bearing
Ensure to align indexing marks of each sprocket when assembling