2002 Ski-Doo Shop Manual Volume Two, Page 173Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
Install slider shoes as per following photoRED slider shoes are being used for reverse and BLACK ones for forward
1, Pulley Retaining Screw
Torque to 22 Nm (16 lbfft)
ADJUSTMENT
Pulley Alignment and Drive Belt Height
Refer to PULLEY DISTANCE AND ALIGNMENT and DRIVE BELT to perform adjustmentsLoosen screws no12, turn adjustment ring no13 then retighten screws to adjust drive belt heightCAUTION: Drive belt and pulley adjustments must always be checked whenever pulleys have been removed, replaced or disassembled
Make sure to install proper camRefer to TECHNICAL DATACam angle is identified on cam
1BLACK slider shoe 2RED slider shoe