2002 Ski-Doo Shop Manual Volume Two, Page 165Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Insert spring and slider shoes into governor cup so that groove in each slider shoe is vertical to properly slide in guidesCAUTION: Make sure O-rings are installed on slider shoes and that grooves are positioned verticallyInstall fork (PN 529 005 500) into slider shoe grooves to maintain them for governor cup installationProceed on set of slider shoes
INSTALLATION
WARNING
Do not apply anti-seize or any lubricant on crankshaft and drive pulley tapers
WARNING
Never use any type of impact wrench at drive pulley removal and installationClean mounting surfaces as described in CLEANING above
529 005 500
Drive Pulley Ass'y
The following installation procedure must be strictly adhered toInstall drive pulley on crankshaft extensionInstall new conical spring washer with its concave side towards drive pulley then install screw
A16B02A