2002 Ski-Doo Shop Manual Volume Two, Page 146Get this manual
Section 04 ENGINE Subsection 08 (CARBURETOR AND FUEL PUMP)
Adjust choke cable to obtain maximum gap of approximately 0.3 mm (.012 in) between tab and plunger when choke lever is not activated
Mach TECH PLUS
TESTING
A06C2MB
Solenoid is supplied by the MPEMIf this MPEM does not work, there will be no current on the compensation solenoid RDBU and BRBU connectors (6-VA housing)Unplug compensation solenoid wireConnect good solenoid to MPEM output connectorThe air temperature sensor must be at room temperatureOperate the engine at 4000 RPMThe solenoid must vibrateStart the engine and observe the solenoidA vibrating solenoid indicates that the MPEM is in good working orderIf not, replace the MPEM and repeat test
10.3 mm (.012 in) gap maximum