2002 Ski-Doo Shop Manual Volume Two, Page 145Get this manual
Subsection 08
Section 04 ENGINE (CARBURETOR AND FUEL PUMP)
Full Throttle Adjustment
To avoid stress on throttle cable when throttle lever is against handlebar grip, stop screw must not contact stopperThere must be slight free play (up to 0.5 mm (.020 in)) between stop screw and its stopper
A06C2IA
1Spacer and spring on PTO side 2Ferrule screw aligned with rod hole 3Dielectric grease
A06C0LA
TYPICAL FULL THROTTLE POSITION 1Free play between stop screw and its stopper
Apply dielectric grease (PN 293 550 004) on cable housing endAll plungers must start to open at the same timeBend ferrule end as requiredDo not change position of ferrule on rodIts screw must remain in line with choke rod hole