2002 Ski-Doo Shop Manual Volume Two, Page 141Get this manual
Subsection 08
Section 04 ENGINE (CARBURETOR AND FUEL PUMP)
WARNING
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as they are flammable and explosiveCheck inlet needle tip conditionIf worn, the inlet needle and seat must be replaced as matched setNOTE: Install needle valve for snowmobile carburetor onlyIt is designed to operate with fuel pump systemCheck throttle slide for wearReplace as necessaryCheck idle speed screw straightnessReplace as necessaryCheck for fuel soaked into float no12; replace as necessaryCheck float for cracks or other damages affecting free movement; replace as necessaryInspect throttle cable and housing for any damagesReplace as necessary
For MAG side carburetor, raise throttle slide half way then unscrew Allen screws2 3
A06C0KA
1Allen screw 2Arm moved aside 3Locking screw and adjusting nut removed
DISASSEMBLY AND ASSEMBLY
NOTE: To ease the carburetor disassembly and assembly procedures it is recommended to use carburetor tool kit (PN 404 112 000)