2002 Ski-Doo Shop Manual Volume Two, Page 114Get this manual
Section 04 ENGINE Subsection 02 (809 ENGINE TYPE)
5, Water Pump Housing
Water pump housing must be sealed with sealing compound (PN 420 297 905)Spread seam of 1.2 mm (116 in) maximum in diameter on surface of water pump housingTighten water pump housing screws to 10 Nm (90 lbfin) following sequence as illustrated6 10 12
420 876 516
A06C1RA
8,9, Plastic Gear and Steel Gear
Apply Molykote 111 to needle bearing of each gearInstall plastic gear on oil pump sideSteel gear goes on water side7 11
A06C3RA