2002 Ski-Doo Shop Manual Volume Three, Page 357Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decalsUse only in well ventilated area
WIRING HARNESS
WARNING
Ensure all terminals are properly crimped on the wires and that all connector housings are properly fastenedKeep wires away from any rotating, moving, heating and vibrating partsUse proper fastening devices as required
WARNING
Before installation, ensure that all cables are in perfect conditionProperly install the cable ends and secure them in placePay attention to route them properly, away from any rotating, moving, heating or vibrating parts