2002 Ski-Doo Shop Manual Volume Three, Page 350Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Loosen the jam nuts on tie rod no8 (LH threads on steering column end) and turn tie rod accordinglyRetighten the jam nuts to 18 Nm (159 lbfin)
WARNING
Never lengthen this tie rod so that threaded portion of ball joint exceeds 20 mm (2532 in)CAMBER NOTE: Identical adjustments are required on both sides of the vehicle Make sure the vehicle is leveled by placing an angle finder under the main frame member as shown on the following illustration Vehicle skis must be off the ground
Adjusting Loosen lock nut on both upper control arms Unbolt both upper control arms at ski leg housingTurn tie rod half turn at time to obtain the specified value when skis are not touching groundBolt upper control armsMODEL MX Trail MX STDXAdrenaline Grand Touring Summit Legend CAMBER 1.0 -1 -2 0
NOTE: Because of negative camber, skis will lean toward center of vehicleTighten lock nut on both upper control armsHANDLEBAR AND SKI TOE-OUT Check that handlebar is horizontal when skis are in straight ahead position by measuring from the extremities of the grips to the rearmost edge of the tunnel, as shownNOTE: The reference point must be the same relative to each side