2002 Ski-Doo Shop Manual Volume Three, Page 343Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Summit After grip installation apply few drops of Loctite 495 (PN 293 800 021) 10 mm (38 in) deep between grip and handlebarLocate former rivet hole in handlebar then, drill 4.8 mm (316 in) diahole through grip in this positionInstall rivet no3All Models Except Summit Locate former rivet holes in handlebar then, drill 4.8 mm (316 in) diahole through grip in this positionInstall rivets no3 both sides of handle
Unbolt nuts and bolts retaining clamp, front and rear arms1 2
Tilt Handlebar Mechanism
Grand Touring SE Only Move handlebar to its higher positionRemove Allen screw retaining locking leverPull out locking leverRemove steering padUnhook throttle cable from throttle leverUnscrew all nuts and bolts securing handlebarNOTE: Do not unbolt master cylinder needlesslyMove handlebar apart, keeping master cylinder reservoir in upward position