2002 Ski-Doo Shop Manual Volume Three, Page 342Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
DISASSEMBLY AND ASSEMBLY
Grips must be carefully removed to prevent damaging the heating elementsRemove rivet no3 on so equipped modelsHeat grip with heat gunApply tape to handlebar near the grip to protect paintInject compressed air into the handlebar and twist grip as pulling it out
Continue cutting along the gap and remove the gripIf required, slowly peel heating element no15 from handlebar and remove itTo install, stick the heating element to the handlebar making sure the wires do not interfere with operation of the accelerator or brake handlePrior to install grips, position heating element protector no14
A30G0DA