2002 Ski-Doo Shop Manual Volume Three, Page 327Get this manual
Section 07 REAR SUSPENSION Subsection 04 (SC-10 III SUSPENSION)
NOTE: As general rule we suggest replacing the damper rod lock-nut after rebuilds to ensure good Iocking friction and use Loctite 271 each timeNOTE: If revalving is to be done, it is imperative that you identify the original shim pack (size and number of shims)The seal carrier need not be removed if only revalving is to be doneShims can be measured by using vernier caliper or micrometerNOTE: All shims should be carefully inspected and any bent or broken shims must be replaced for the shock to function properlyAfter the new or replacement shim pack has been selected, reassemble in the reverse order of disassemblyTorque piston nut 2729 Nm (2021 Ibfft)1 3
A32F1XA
Rebound dampening shim pack Rebound dampening shim pack Piston Compression dampening shim pack Compression dampening shim pack Stopper
A32F1WA