2002 Ski-Doo Shop Manual Volume Three, Page 279Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
If no beeping signal is heard when switch is turned on, check if either the headlight or the taillight is onIf this is the case, then the bypass wire was incorrectly installedTurn switch off and re-verify that the flat terminal of bypass wire is connected to REDBROWN wireOnce MPEM calibration program checking is done, turn switch offRemove alligator clip from battery positive postRemove flat terminal from fuse holderReinstall 20 fusesTurn on programmer then enter passwordFrom main menu select no3VEHICLE INFO; Trs
Select no3 CALIBRATION
1TIMING ADJUST 2ENGINE SERIAL#AT N
A30E2IA
Press ENTER TrsFollowing screen appears temporarily:
A30E1XA
CHECK KEYS PROGRAM KEY VEHICLE INFO TA RT H