2002 Ski-Doo Shop Manual Volume Three, Page 223Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
1 529 006 500
Pulley Alignment and Drive Belt Height
Refer to PULLEY DISTANCE AND ALIGNMENT and DRIVE BELT to perform adjustmentsDrive belt height is adjusted by turning Allen screws no13 equally and accordinglyCAUTION: Drive belt and pulley adjustments must always be checked whenever pulleys have been removed, replaced or disassembled
Make sure to install proper camRefer to TECHNICAL DATACam angle is identified on cam.3
A01B18A
TYPICAL Step1st measurement Stepnd measurement
To adjust spring pre-load, relocate spring end in cam, moving it clockwise to increase the pre-load and counterclockwise to decrease itRefer to TECHNICAL DATANOTE: If spring pre-load can not be adjusted, try to relocate the other end of spring in sliding pulley (holes A, and C)C A