2002 Ski-Doo Shop Manual Volume Three, Page 213Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
6,25,29, Sliding Half, Slider Shoe and Governor Cup
To install governor cup, use following tool:
529 005 500
A16B01A
Insert spring and slider shoes into governor cup so that groove in each slider shoe is vertical to properly slide in guidesCAUTION: Make sure O-rings are installed on slider shoes and that grooves are positioned verticallyInstall fork (PN 529 005 500) into slider shoe grooves to maintain them for governor cup installationProceed on set of slider shoes
A16D0EA
Carefully slide governor cup into sliding halfAlign mark of governor cup with mark of fixed halfRemove forks and push governor cup so that its splines engage with fixed half shaft splinesCAUTION: Make sure splines of both parts are fully engaged