2002 Ski-Doo Shop Manual Volume Three, Page 212Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
Always install lever assemblies so that cotter pins are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, drive pulley misbalancing will occur because of levers differenceA32D0IA
1Reinforcements
5,6,18,19, Fixed Half, Sliding Half, Spring, Spring Cover and Screw
To install spring cover, use spring compressor (PN 529 035 524)Assemble fixed and sliding halvesNote that fixed halves have different cone angleMatch cone angle with crankshaftLift sliding half against spring cover and align spring cover arrow with sliding half mark